Vugera OBD-II Plug & Play Dashcam Power Cable Kit (Fits: BlackVue X-Series)

• Saves time being wasted searching for B+ and ACC fuse during installation
• A dedicated cable for vehicle protection with an over-current cut-off circuit is needed.
• Switchable recording mode (Driving only or Driving and parking mode)
• Built-in G sensor for wake-up on vehicle impact even when the vehicle is switched off
• Automatic cut-off at 11.8V (overrides lower voltage cut-off settings)
• Compatible: Vugera and BlackVue X-Series (except LTE)

Most automobile manufacturers warn that your vehicle warranty may be void if the vehicle is modified.

If hard wiring is of concern, the VUGERA POWER OBD-II cable is the perfect solution for powering your dashcam. It's a Plug & Play solution (worry-free, no hard-wiring or modification required) for vehicle protection with over-current cut-off circuit

Offers a manually switchable recording mode (S position: Driving only or P position: Driving and Parking mode). Built-in G-sensor for dashcam wake-up upon vehicle impact even S position (when the dashcam is switched OFF)

In the P position, the dashcam enters parking mode when the engine ignition is switched OFF (transition time to parking mode differs on all vehicles. Max. 5 minutes) When no movement is detected via the G-sensor for 5 minutes, the dashcam will switch to Parking Mode (if selected) or else power the dashcam off.

It is designed to automatically cut off the dashcam at 11.8V and enter sleep mode (even overrides the dashcam's lower voltage cut-off settings) OBD power input requires a minimum of 13.1V to power on. Once powered on, it will hold power until 11.1V in parking mode. DC 12V~15V (Max 1.8A), Cable Length: 2m 

Applicable on vehicles that are equipped with a universal OBD-2 port (not for use with electric vehicles)